Husdata Online (if enabled)

When H66 is installed and all seem to work according to LED statuses and web page, it will start uploading statistics to the Husdata online system every 5 minutes.

Log in to Husdata.se with the by mail supplied account to view real-time information, build reports and configure notification for certain thresholds. It will take 5 minutes before you see the first data.

H66 Web interface

Menu-Home
Status
Gives you an overview of your H66 status like its Version, Signal strength, Uptime and statistics.

Heat pump status, parameters and data
A list of the heatpump sensors and status for the heat pump and their current value is shown.

Heat pump settings
In the list there are darker grey marked rows. These are settings you can change in the heat pump. For example indoor temp and heat curve settings.

Manage power setting.
For on/off registers and Percentage register you can set its power consumtion to track the Pumps energy usage. See the Power measurement guide for more info

Manage custom registers
At the bottom of the page you have the link to custom registers page. This is for advanced users that would like to add additional registers to read from pump. See separate guide for custom registers.

Menu-Config
View and make changes to the configuration. See full parameter list in other section of this manual.

Menu-Log
View the last messages from the H66 system. You can browse the previuos ligs with the buttons. The Log if very useful for troubleshooting and verification of operations.

Menu-Support

Support Ticket
Use the ticket function of you like to ask a question or need help. Check the box for Configuration to include it in the ticket. You will get a copy by mail.

Remote Assistance
The H66 can connect to Husdata support server over an agreed port. This enable Husdata to remotely access the H66 for development or sorting out problems with the unit. To enable Remote Assistance, enter the port number that has been agreed with Husdata as part of the case.

Update H66 firmware
View the current version, release-notes and new available version of the H66 firmware. If they differ you can update your unit by selecting the “UPDATE” button. The update takes about 45sec. Wait one minute before trying to access to unit after an upgrade and verify that it has got the new version installed. Please don’t disconnect the H66 from power while it is updating. After update, please view the Configuration if there are any new parameters that has been added needing attention.

Run console command
For advanced troubleshooting and management, the H66 has a command-line interface (CLI) available when connecting it to its USB/Serial port. Here you can run CLI commands from the web interface. Note that the CLI response will not be visible via web interface. See specific CLI section for more information.

Factory reset config:
Use to reset different parts of configuration to factory config if H60 if needed

Restart the unit
Restart the H66

Menu-Logout

Logging out from H66 if password is enabled